CDTXLR2 Countdown Timer with Strobe and Pace Cycle CDTXL R2 -Pace

 

The CDTXLR2-Pace is our latest version of the large character high visibility LED countdown timer. This model is ideal for process Pace Time/Takt Time countdown cycling.  This timer can be set to count down from a preset (adjustable using the IR Remote) time cycle, and the Pace feature allows for an automatic reset or cycling of the count down time with a duration of strobe flash, or optional horn sounding in between cycles. As an example, a 30 minute cycle time could be set, and once the 30 minutes has expired there can be a 3 second period of flashing strobe while the cycle of 30 minutes has already begun, or the 30 minutes in this example can be set for 29 minutes and 57 seconds assuming the strobe would be set for 3 seconds--totaling the 30 minute cycle ended with the stop of the strobe. The duration of the strobe flashing, or optional horn sounding is also adjustable internal to the timer. This model incorporates a flashing strobe light that begins flashing at the zero time of the countdown. Additionally, an optional horn can be added to provide an audible alarm to increase the "Attention getting" ability of this timer.  The CDTXLR2-Pace allows the time cycle period to be adjusted using the IR Remote, the remote can also be used to pause and restart the cycle time. One of the IR Remotes is included no matter the quantity of timers purchased--select additional IR Remotes when ordering below if required. Operation for this configuration: a customer specified time is programmed for this 4 digit display, and once the time is counted down to zero, the internal contact triggers the attached strobe light, which continues to flash until the internal automatic reset (customer adjustable) is triggered, which begins the pace cycle again. This model is available without a visual signal--please select this option when ordering. 120 Volt AC power cord of 6 foot length is included. Custom versions are available, and may be added to signaling assemblies on our site--please inquire. Large 2 1/2" characters allow for 100 plus feet of viewing. Wall mountable within reach for local reset and On/Off switch activation. Wall mounting stainless steel tabs are included. An Optional 10 foot cable with reset switch can be installed if desired--select below. Enclosure dimensions are 11" in length across x 7 3/8" in height (not including the strobe)x 5 1/4" deep. Select the time frame of: Minutes and Seconds, or Hours and Minutes when ordering below--this can be changed if necessary by the user.